Jesada Catalog


List All Products


Advanced Search





Forgot your password?
Forgot your username?
No account yet? Register

VirtueMart Shopping Cart

VirtueMart
Your Cart is currently empty.



Attention: open in a new window. PDFPrintE-mail

Jesada's
Raised Panel Bit Instructions


Warning!  Router Table Use Only! Please Note: Wherever you see these pictures, the specified bits are for use in a router table only! Never attempt to use them in a hand-held router!

Choose from four popular panel profiles!
These bits are perfect for 5/8" thick door panels.


Cut Profile

Cut Profile

Cut Profile

Cut Profile
Raised Panel IllustrationCut your panel to finish size. If your rails and stiles are 2-1/4" wide, the panel should be about 3-7/8" narrower and 3-3/4" shorter than the finished door dimensions. Set up your panel-raising bit as shown. The tongue of the finished panel should slip easily into the groove you made in Cut #1 of the Rail & Stile instructions. Don't make your panel so tight you must force it into the groove, and never glue your panels into the frame. A few words of caution: Take Your Time! These bits can remove a great deal of stock in a single pass, but it's neither safe nor productive to push them to the limit. Make several passes, cutting a little deeper each time. Besides the obvious safety factor, you'll produce much better panels!

This bit is to be used in a router table with fence only!
Copyright © 1997, Jesada Tools™.
Any reproduction in whole or in part strictly prohibited.